Vincent G.
Build plate is great. My prints are sticking perfectly during printing and after it cools off they come off with no effort.
Henri N.
No adhesion issues and prints are better. Best update ever.
Colin K.
Great product, big upgrade over the stock print surface. Wish I had upgraded before.
Tyler K.
Really good bed adhesion! No glue needed however do not use the scraper or you will damage the coating. Highly recommend!
Charlie G.
Stuck so well I had tk put it in freezer to remove it from bed. Did not even have to change any settings , just relevel the bed and print !
Benoit P.
Love this glass bed! Great addition to my CR20 Pro. Not one failed print using the textured glass side! A little too good adhesion sometimes, but easy to remove with a knife under one corner. The flat glass side is also great for ultrasmooth finish, and a bit of hairspray garanti good print with PLA. Thanks for the fast shipping (next day!)!
Thomas B.
Great way to ensure a completely flat bed surface with no dips or high areas. Good print adhesion as well until the bed has cooled down.
luc b.
Wow. Avec du fixatif a cheveux. Sur le côté lisse. Ça colle sans aucun print brisé. Mes meilleurs upgrade à ce jour.
George M.
Well used and works as it says
Mark v.
These are much better quality than the ones for sale on Amazon (which I am pretty sure are knock off Creality).
Peter-Thomas K.
I bought this plate at the same time that I bought my Ender 5 Pro.
I didn't install it right away, I wanted to get things going with the magnetic bed first to make sure everything was working right (I had gone through 2 defective printers from a different brand and supplier the previous week).
It printed ok, but I was having minor issues that I couldn't figure out, so I decided to throw the glass bed on and all my problems disappeared! Prints stick well to the surface and release like magic! (I've only had one print that was a bit hard to get off, but it was my fault, had the z-axis way too tight, the rest of the prints I can literally blow off!)
I definitely recommend this surface!
mike b.
I quite liked the original bed for PLA but want to look at other materials and their heat requirements may exceed it's recommended capabilities. Once set up, the finish of the print contacting the bed is impressive. You can use glass or a mirror but the coated surface releases without having to deal with extra steps in prep and clean-up.
Shawn R.
This is my go to print bed now, used with Magigoo and printing with PLA the prints just pop off by hand after the print bed has dropped below 28 degrees. Just watch some of the "silk" pla filaments stick a little much to the glass, great product and good to see 3D Printing Canada stocking all that is needed.
