Unmatched Bed Adhesion!

Designed for PEEK, ULTEM™, PPSU and other high-performance FDM polymers, this build plate adhesive works for nearly every filament. Whether it's Nylon, ABS, PLA, PETG, PEI, PSU or almost anything else.

   •   Designed for PEEK, PEI and high temperature materials

   •   No mess like Glue Stick or Hair Spray with better gripping power

   •   Works on many different build surfaces

   •   Easy to clean and re-apply

   •   Works with normal temperature materials like ABS, PLA and Nylon

   •   Made from safe, non-toxic, organic compounds

Works on most surfaces:

Tested to work on: Borosilicate Glass, Ceramic Glass, PCB board, FR4, Garolite, Carbon Fiber, Creality Glass (non-coated), Fiberglass, BuildTak™, PEI, WhamBam, Flex Plates, Kapton tape, and more!

How to Apply:

   •   Clean your build plate, use water, windex or alcohol

   •   Apply adjesive and spread evenly on Build Area

   •   Calibarte your first layer height

   •   Print you part

   •   Remove part

High Temp

When you're extruding over 300°C, remove the part as quickly as possible. You wante the build plate and part to be HOT when you remove it - high-temp materials contract extremely quickly when cooling, and parts can shatter glass in less than 30 seconds. This is why we recommend carbon fiber plates for high-temp materials.

Low Temp

When you're extruding below 300°C, generally you can remove the part as soon as the plate cools. With materials like PLA or PETG, it usually pops itself off the plate. If it sticks too much, you can apply water around the base of the part, which will help it release. Make sure your first layer is PERFECT - if it is too close, even without adhesive, ABS and PETG will break and chip glass.

Click here for the Safety Data Sheet